Kategória: Lakás, otthon, kert, barkács
Honlap:
Részletek... Flexible mono-crystalline panel with mounting lugs at panel corners, 100cm cables with MC-4 terminals. The panel is lightweight and partially flexible. Technical parameters: Max. no-load voltage Voc=21,24V Max. short-circuit current Isc=1,22A Max. voltage at 80W output: Vmp=18V Max. current at 80W: Imp=1.11A Max. system voltage: 500V Dimensions 350x430x2,5mm / 0,7kg Description of the monocrystalline cell To produce a single crystal cell, a uniform quartz crystal ingot needs to be produced. Such production is quite demanding. The round ingot is cut into so-called wafers, which are trimmed to the required size of the PV cell. Because the ingot is formed as one large silicon crystal, its structure is uniform and very clean. Advantages of single crystal Higher cell efficiency and therefore higher power yield from the same area Slightly slower aging of the silicon, i.e. panel performance declines more slowly with time Cell coloration is homogeneous, panels are not speckled Installation If the flexible panel is glued to the roof of a vehicle, caravan etc., the different expansions of the roof and panel material must be taken into account, which can cause damage to the flexible panel. It is recommended to glue the flexible panels on an intermediate layer made of Makrolon Plaxiglas, which also allows air to flow under the solar panel, thus increasing its efficiency. Please note: the flexible panel can only be bent with the longer side at a maximum angle of 25°.
